(press the buttons above to move around the site)
Toby sent the following about his vice: There are two pieces of square tube that slip together. The inside one is welded to the one vice leg and a 3/4" nut is welded to the other end. On the outside tube is welded a blank with a 13/16 hole drilled in it. I did the drilling then the welding. Then I put a 3/4 Ready Rod through the hole, started it into the welded nut inside. Put a washer on the outside with another nut, with the handle welded onto it and pinned that nut to the Ready Rod with a 1/4" roll pin.
|
![]() |
|
I've seen enough, take me to the Order Page.
Phone (775) 588-6074 (8 to 5 PST, M-F only)